
Fuji Xerox ApeosPort-II C4300(AP)Series Security Kit for Asia Pacific Security Target V1.01
- 9 -
firewall.
2.3. Purpose of Using TOE
To protect the used document data that is stored on the internal hard disk drive of
MFP from being disclosed illicitly.
2.4. Configuration of TOE
2.4.1.
Physical Configuration
Each unit in MFP and physical boundaries within TOE are shown in Figure 2.
MFP consists of three board-units: controller board, control panel, and
facsimile card.
Controller board and control panel are connected via the internal interface where control data are
communicated.
In each of the following sets, the two are connected via the internal interface where document data
and control data are communicated:
- controller board and facsimile card
- controller board and IIT
- controller board and IOT
Controller board is a circuit board to control copy, printer, scanner, and facsimile functions of MFP.
This board has a network interface (Ethernet) and local interfaces (IEEE1284 and USB), and is
connected to IIT and IOT.
Control panel is for operating / making settings on copy, printer, scanner, and facsimile functions of
MFP.
Facsimile card is a circuit board to control facsimile communication using public telephone line
network.
TOE is a set of programs that are recorded in the system ROM that is mounted on the controller
board. Programs recorded in the ROM, which is a physical configuration item of TOE, are shown in
Table 1.
Table 1: Physical Configuration Item of TOE
Configuration item Stored program
System ROM Programs to control MFP are recorded in the system ROM, and the following
functions are provided:
- Copy control function
- Printer control function
- Scanner control function
- Facsimile control function
- Control-panel control function
- Key-operator authentication function
- HDD overwriting function for residual data
- HDD data encryption function
- CWIS
Comentarios a estos manuales